Features and advantages of uvled point light curing machineread count [314] release time：2020-01-03 19:57:00
uv led The principle of the purple light curing system is to use energy to uvled The high-power diode chip produces high-purity 365nm monochromatic purple light, which ensures that the energy is concentrated within the wavelength range required for UV curing. The difference between uv curing lamps and traditional high-pressure mercury lamp curing equipment is that the ultraviolet rays emitted by traditional curing machines during the production process are very bright and release a lot of heat. This will not only damage the eyesight of the workers, but also cause a lot of waste. In fact, the spectrum of traditional light sources is very wide. Only the purple light can be truly effectively utilized, and most of the rest is lost as heat. On the other hand, since the problem of large heat generated by this light source has not been solved, the damage to the workpiece is also relatively large, and uvled point light source It is a cold light source, which effectively guarantees the life of the light source. So what are the obvious advantages of curing equipment made with UVLED light sources?
In terms of production costs, the cost of uvled point light sources is significantly lower than the cost of traditional mercury lamps, which can effectively save costs.； In terms of energy configuration, the UV point light source can have 1-4 channels, has stable performance, and can control four irradiation heads with one host. It is also a huge advantage in field applications, such as curing and glue bonding in the mobile phone industry. UV point light sources are divided into two categories: one is traditional: Japanese USHIO, Panasonic, etc.; the other is LED.
1. Due to the lighting method of UVLED point source lamp, the continuous life is more than 20,000 hours. It uses energy-saving design and only needs lighting when lighting is needed. Low power consumption: about 50W.
2. LED point light source body light, you can easily integrate it into the automatic assembly process, or it can be installed on a small device as a complete desktop system.
3. The LED irradiation head is controlled by the computer CPU. Manual or automatic control operation can be selected according to actual needs, and the time required for lighting can be set to further support high-precision connection requirements and reduce the time error of human operation.
4. LED curing equipment has almost no heat, is not fragile, has no mercury; and has no maintenance costs. At the same time, the new UV point light source is equipped with a special condenser lens assembly to concentrate the energy at the curing point and improve UV glue The curing efficiency is high, and 4 channels can be added at the same time to increase the exposure area.
